Bond It Heavy Duty ALKYD FLOOR PAINT Brick Red 5 Litres
A high solids, low viscosity, hard wearing, heavy duty alkyd formulation floor paint for use internally on concrete, wood, brick and stone. Designed to give a hard-wearing, easy-clean finish to concrete, stone, brick and wooden floors subject to light to medium traffic including forklift trucks and scissor lifts, etc. Suitable for use on garage floors, warehouses, workshops, factories, storerooms, pedestrian walkways and is designed to give enhanced durability, abrasion resistance and good resistance to dilute acids/alkalis and oils, including brake fluid, engine cleaners, screen wash, anti-freeze, power steering fluid, diesel and sump oil. Dries to a satin finish.
Concrete must be a minimum of 6 months old before the paint can be applied. Priming isn’t usually required, but if necessary apply a coat of 1 part white spirit to 4 parts paint and allow to dry. Bond It Floor Paint is touch dry within 2-3 hours depending on ambient temperatures. Please note that low temperatures can significantly affect drying time. This product is ready to use the product and does not require diluting. Apply using brush or roller to give even coat. 2 coats are usually required, requiring 16-24 hours between each coat. Will dry to a satin finish. Clean tools and brushes with white spirit. Cured paint can be removed using xylene. For internal use only.
All surfaces must be clean of any contaminants such as dust, oil, etc. and dry (to the touch). Remove any loose or flaking material with a scraper and stiff brush to expose a smooth debris-free surface. Remove any moss, mould or lichens with Bond It Mould-Stop! Chemically or mechanically hardened floors may require abrasion prior to use. If in doubt test a small area prior to full application.
How To Use
- This product is ready to use and does not require diluting.
- Apply using brush or roller to give even coat, 2 coats are usually required.
- Bond It FLOOR PAINT is touch dry within 2-3 hours depending on ambient temperatures, leave 16 to 24
hours between each coat.
- Clean tools and brushes with white spirit.
- Cured paint can be removed using xylene (paint stripper).
- Priming isn’t usually required, but if necessary apply a coat of 1 part white spirit to 4 parts paint and allow to dry before proceeding.
New concrete must be a minimum of 6 months old before painting. Do not use on concrete floors with a moisture level reading above 18%, that does not have a waterproof membrane or that contain dust suppressing additive. Only suitable for light to medium traffic, for areas subject to heavy traffic or constant use, an epoxy-based paint would be
recommended. Do not traffic until fully cured. Not suitable for use on bitumen or asphalt.
Approximately 15-24m2 per litre (1 coat).