Bond It WOOD PRO Buff EU3
Bond It has been a manufacturer of high performance and high-quality building chemicals such as sealants, adhesives, grouts, cleaners, expanding foams, fillers, decorating sundries, landscaping products and many other similar products, for almost two decades.
Bond IT serves customers across Europe, the Middle East, Africa, Asia and North America and offer a comprehensive range of competitively priced products which cater for the widest range of needs.
Bond ITs focus on quality is such that they have long held ISO9001:2008 accreditation and also operate stringent quality control procedures that cover all aspects of their manufacturing operations and service delivery.
Bond IT aim to exceed expectations and their company strapline of ‘Never compromise on quality’ is more than marketing speak.
A permanently flexible, one part, ready to use, moisture cure, internal wood flooring adhesive supplied in a plastic cartridge. Free from silicone, solvent, isocyanates and water. Based on hybrid polymer technology; Wood Pro reduces the risk of warping or deforming the wood flooring due to its moisture and solvent-free composition.
- Solvent and moisture-free
- Quick cure and rapid bond strength
- Permanently elastic
- Suitable for use with underfloor heating.
For the internal bonding of parquet, mosaic, oak, woodblock, laminated, exotic timber and many other wood floor types to porous or non-porous substrates including; screeds, chipboard, plywood, concrete and anhydrite. Compatible with substrates incorporating under-floor heating systems. Use the notched nozzle provided for maximum transfer. Apply the adhesive to the substrate in a triangular bead 8mm wide by 10mm high and at 250mmcentres at right angles to the length of the wood. Do not apply more adhesive than will be used within 20 minutes of application. To ensure maximum transfer of adhesive to the wood, lay into the adhesive with a slight twisting motion and tap into place.
All surfaces must clean, dry and free from, grease, polish, old adhesive remnants or any other contaminants that may hinder adhesion. Loose, friable or cracked areas should be repaired prior to application. The moisture content throughout the substrate should be checked by Hygrometer, ensuring that the moisture content does not exceed
that recommended by the wood flooring manufacturer for the particular substrate. In particular, Anhydrite levels would differ to those of concrete. The wood flooring should also be checked that the relative humidity figure falls within those recommended by the manufacturer. Note; underfloor heating systems should be turned off 48 hours
before and 48 hours after application. All wood flooring should be acclimatised for several days in the room where it is to be installed.
How To Use
- The application temperature should not be below +10o C and not above +30o C, materials should be
acclimatised to this temperature in the intended application site prior to installation.
- Solid floors should have an existing DPM in place.
- Use the notched nozzle provided for maximum transfer.
- Apply the adhesive to the substrate in a triangular bead 8mm wide by 10mm high and at 250mmcentres at right angles to the length of the wood.
- Do not apply more adhesive than will be used within 20 minutes of application.
- To ensure maximum transfer of adhesive to the wood, lay into the adhesive with a slight twisting motion and tap into place.
Wood Pro will take at least 24 hours to cure assuming a temperature of 23OC at 50% RH. Cooler and/or less humid conditions will extend drying times. Wait until the adhesive has fully cured before sanding or finishing the flooring.