Free Super glue with all orders
£10 off when you spend £100 or more Enter: 10off
Free UK Shipping

Resin Mortar Anchor Bond Adhesive Grey 310ml Fixing Bolt Stud Securing

£13.95

18 sold

Dispatch Time: Same Working Day
View and buy this product Right Now, from the Bond It Shop eBay Store

8,000+ ⭐⭐⭐⭐⭐

Resin Mortar Anchor Bond Adhesive Grey 310ml Fixing Bolt Stud Securing

New Professional Trade Quality Product

A 2-part system applied in one single action to produce a cost-effective, tough chemical resistant fixing. The ideal day to day applications including railings, steel structures, satellite dishes, fire surrounds, gates, sanitary fixings/towel holders, pipes and lamps. Use of Anchor Bond makes the fixing an integral part of the substrate as the load is spread throughout the entire fixing area as opposed to when plastic plugs or mechanical fixings are used especially in friable or cracked substrates.

Application

Suitable for setting bolts, studs, wall ties, starter bars or large screws, etc. into a wide range of substrates. Compatible with brickwork, concrete, masonry, stone and aerated concrete blocks. Ideal for close-to-edge applications (unlike expansion anchors) as no stress is placed on the surrounding substrate. Full cure is obtained after 2 hours.

310ml so does fit a standard sealant applicator gun (see our shop) though we recommend the Anchor Bond Pro Gun Applicator for day to day use. (See our shop).

Spare nozzles are also available (sold in bags of 10, just ask and we can order in).

Drill a hole to the correct diameter and depth, ideally using a rotary percussion machine. For optimum results, the wall sides should be thoroughly roughened. Clean hole and remove all dust and debris using a hand air pump or a stiff rotary brush, if required. All bars should be clean and free from oil or grease and all flaking rust should be removed. Threaded rods or studs should be chisel ended to prevent them from being unscrewed from the cured resin.

How To Use

  • Screw the mixing nozzle on to the cartridge (hand tighten).
  • Place the ANCHOR BOND cartridge into the dispensing gun.
  • Squeeze the hand trigger a few times until material passes through the mixing nozzle.
  • Allow the material to flow until an even colour is obtained (normally 5-6 inches).
  • Insert the nozzle into the base of the hole and extrude material, half filling the hole with resin.
  • Withdraw the nozzle then insert the fixing into the filled hole, slowly rotating to fully coat the surface.
  • After application release the pressure from the dispensing gun.
  • Remove the used mixing nozzle and wipe away excess material from the end of the cartridge.
  • Once the resin has cured the fixture can be attached to the fixing and fully tightened.
  • Do not over pressurise cartridge otherwise leakage may occur from rear pistons.

 

Curing:

  • Dependent on temperature. As a guide @ 20C –
  • Gel Time: 5 minutes.
  • Full Cure: 2 hours.

Colour:

  • Grey

Size:

  • 310ml

Additional information

Weight 2 kg
Dimensions 50 × 50 × 260 cm
Brand

Bond It

Manufacturer Part Number

BDAB310

Size

Colour

Grey

EAN

Reviews

There are no reviews yet.

Be the first to review “Resin Mortar Anchor Bond Adhesive Grey 310ml Fixing Bolt Stud Securing”
  
comments about site?

Shopping cart

0

No products in the cart.