Roof Repair Waterproofer Spread It on Trowel Mastic Added Fibre Seals gaps cracks Apply It Job Done 2.5L
Brand New Trade Quality Product
A heavily filled and fibrated bituminous compound that dries to a soft flexible black coating which remains soft and pliable for a long time after application.
Bond It TROWEL MASTIC is a multipurpose trowel grade material for waterproofing, stopping, bedding, pointing and sealing. TROWEL MASTIC can be applied to mastic asphalt, roofing felt, corrugated iron, cast iron, fibre cement, slates, lead, copper, zinc, concrete and timber.
All surfaces must be structurally sound, clean, dry and free from surface contaminants such as grease, rust and dirt. If necessary, remove any organic growth i.e. lichen, with a fungicidal wash such as Bond It Mould Stop. If the surface is still dusty after cleaning, or covered with weathered bitumen, prime with BITUMEN PRIMER and allow to dry. To assist application in cold weather store the material in a warm room overnight prior to use.
Apply with a steel trowel or putty knife.
Cracks & holes: Force the compound into the crack leaving slightly proud at the centre. For large cracks and holes apply the compound over the area to be treated and embed a closely woven glass fibre membrane into the compound to overlap the crack or hole by approximately 50mm. Allow to dry and then apply a second coat fully covering the reinforcing membrane.
Corrugated iron/fibre cement sheeting: Tighten loose hook bolt and trowel around with TROWEL MASTIC. Remove loose screws then re-bed both screws and washers in TROWEL MASTIC and tighten. Top seal and trowel to a smooth finish. If a sheet is cracked clean, prime and apply a bandage strip of woven glass membrane embedded in TROWEL MASTIC. Allow to dry and then overcoat. Where required use the same technique to seal side and end laps in corrugated sheeting. Tiles: Use TROWEL MASTIC to point up butt ends of ridge tiles, fillets and slates.
Lead and zinc: Trowel over cracks and pinholes, where necessary reinforce with a woven glass fibre membrane embedded in TROWEL MASTIC and overcoat.
Felt: Re-adhere loose felt (especially flashings and details) and seal joints with TROWEL MASTIC. Note: this material should only be applied to surfaces that are completely dry and great care should be taken to ensure that when applied to bitumen felt no moisture is contained within the felt.
Most of the solvent evaporates in 24 hours under average drying conditions, but the coating remains soft for many months.
Note: this information is for general guidance only, since site conditions and labour are beyond our control. It is recommended that users make their own tests to determine suitability
Limitations • Do not use in areas where subsequent solvent contact is likely. • Do not use for potable drinking water tanks. • Allow sufficient drying time between coats. • Bitumen paint may bleed through any paints subsequently applied over it. Apply a primer recommended by the paint manufacturer before overpainting.
Approximate Coverage: 2m2 per litre (giving 2mm wet thickness)
Service Temperature Limits: 10o C to +85o C depending on operating conditions
Application Temperature Limits: Normally 5o C to 30o C
Chemical Resistance Resistant to: most salt solutions, some dilute acids and alkalis, water and alcohol Not resistant to: oils, solvents some detergent solutions
Heat Flow Resistance: The cured film will not sag or flow under normal conditions
- 2.5 Litres
Any questions just ask and we’ll do our best to help.